Complete the steps below in order to use your SoClean 3
SoClean is powered on (page 20)
Filter is installed (page 22)
Sleep equipment hose and mask are washed in sink and
dried before first use (page 24)
SoClean Adapter is installed on sleep equipment hose
Ensure the Ozone Tube is connected to the back of the
SoClean 3 and the SoClean Adapter
Sleep equipment hose is still connected to mask
ONE-TIME DEVICE ACTIVATION: The Lid must be closed
and the mask and hose outside the Chamber. Firmly press
the Control Panel buttons in the following order:
If the Cycle Complete icon is green ,
your device is ready to use.
If the activation was unsuccessful, press the Lid Open button
to open the Lid. Close Lid. Restart DEVICE ACTIVATION.
The SoClean 3 can be used daily to supplement your manufacturer
recommended hose and mask cleaning routine.
Wait a minimum of 30 minutes between completion of the Cycle and use
of the sleep equipment mask and hose.
Press the Lid Open button
to open the Lid.
Ensure your SoClean 3 is ready for use by completing the steps on
the setup checklist.
STOP: ensure you are following your manufacturer’s
recommendation to properly wash and dry your sleep equipment
hose and mask before first use of SoClean 3 and as part of your
ongoing cleaning routine (page 24).
OPERATING A
MAINTENANCE CYCLE
WARNING: The Ozone Tube must always be
connected to the SoClean Adapter and the back of
the SoClean 3 unit when operating the SoClean 3.
A
B
1
Setup Checklist &
Device Activation
Using Your SoClean 3
Once you have completed the setup steps, you are ready to begin the daily
maintenance of your sleep equipment mask and hose with your SoClean 3.
NOTE: The Lid will
spring open and
light will illuminate
from the inside of
the bottom of the
Chamber.
28 29
To Next Page
Loading...