SoClean 3

To run the Maintenance
Cycle immediately, press the
Maintenance Cycle button
to start.
You should hear the ozone
generator and air pump turning on
and o periodically over the 1 hour
and 15 minute Maintenance Cycle.
Make sure the sleep equipment
hose is connected to the SoClean
Adapter and the Ozone Tube is
properly connected to the Adapter
and to the back of the SoClean 3.
Place your mask into the Chamber
and route the mask hose through
the Hose Slot.
NOTE: Some head gear contains nylon which is not compatible with ozone.
It is recommended to remove head gear before placing the mask into the
Chamber.
CAUTION: In the event of loss of power to your home or the SoClean 3
device during a maintenance cycle, you may want to rerun the entire
Maintenance Cycle to make sure your sleep equipment hose and mask
have been properly maintained.
IMPORTANT: The SoClean 3 device will not operate without the mask and
hose present in the securely closed Chamber. Additionally, the SoClean 3
will not operate if the Filter is not present with the Filter Door closed.
C
D
Push the Lid down until it latches shut.
CAUTION: Rest the flexible part
of the hose, not the rigid mask
connector, in the Hose Slot to
ensure a proper seal.
CAUTION: Ensure all tubing and
hoses are free of kinks prior to
operating the SoClean 3.
The Maintenance Cycle button
will illuminate blue to indicate
the Maintenance Cycle is operating.
The Progress Bar on the Control
Panel will illuminate
blue from left
to right as the cycle proceeds to
completion.
U S IN G YO U R S O C L E A N 3U S IN G YO U R S O C L E A N 3
At the end of the
Maintenance Cycle,
the Cycle Complete icon
will light up green.
You can now press the
Lid Open button to
remove your mask and
hose. Wait a minimum
of 30 minutes between
completion of the Cycle
and use of the sleep
equipment mask and hose.
E
NOTE: It is important to leave your mask and hose in the SoClean 3 for
the complete Cycle duration to ensure full maintenance of your sleep
equipment mask and hose. Leave the room for the duration of the Cycle.
The SoClean will operate the air pump and circulating fan for the last 12
minutes of the Cycle duration to move fresh air through the system.
Your sleep equipment mask and hose are ready for use!
If you need to remove your sleep equipment mask and hose before
the Maintenance Cycle is complete, see the “Canceling a Cycle” section.
See Step 2 if your hose requires a Hose Sleeve.
30 31