SoClean 3

U S IN G YO U R S O C L E A N 3
At the end of the Fresh Air Cycle, the
Cycle Complete icon will light up
green. You can now open the Lid and
remove your mask and hose.
NOTE: You can run only 3 consecutive
Fresh Air Cycles before you must run a
Maintenance Cycle. This ensures that
your sleep equipment mask and hose
are properly maintained.
B
FRESH AIR CYCLE [OPTIONAL]
The Fresh Air Cycle can be used daily to freshen the air in your mask
and hose before use. Typically, your mask and hose will still be in
your SoClean 3 from a Maintenance Cycle and the Fresh Air Cycle
can be started with a simple one-button push. The Fresh Air Cycle
does not maintain your sleep equipment mask and hose.
Place your mask and hose in your
SoClean 3 and press the Fresh
Air Cycle button
to initiate the
process.
The Fresh Air Cycle will take
approximately 5 minutes to
complete. During the Fresh Air
Cycle, the Fresh Air Cycle button
will illuminate blue to indicate
the Fresh Air Cycle is operating. The
Progress Bar on the Control Panel
will progressively illuminate blue as
the cycle proceeds to completion.
NOTE: Running a Fresh Air Cycle
does not reduce the life of the Filter.
A
U S IN G YO U R S O C L E A N 3
CANCELING A CYCLE
If you need to remove your sleep equipment mask and hose while an
active Maintenance Cycle is taking place, you can cancel the cycle.
Press and hold the Lid Open button
for approximately 5 Seconds.
The SoClean 3 will pump air through the
system for approximately 15 minutes after
the Maintenance Cycle is canceled in order
to clear ozone from your sleep equipment
mask and hose.
At the end of the Maintenance Cycle
cancellation, the Cycle Complete icon
will light up green. The Maintenance Cycle
was successfully canceled. You can now
press the Lid Open button and remove
your mask. Wait a minimum of 30 minutes
between completion of the Cycle and use
of the sleep equipment mask and hose.
Your sleep equipment mask and hose
may not have been fully maintained.
WARNING: Do not forcibly open the
SoClean 3 Lid before the Cycle completes.
While the Maintenance Cycle cancellation
is in progress, the following will illuminate:
• Fault/Unable to Run icon
will
flash red for nine seconds.
• Maintenance Cycle button
will
illuminate blue
• Progress Bar on the Control Panel
will flash blue
The Lid will remain locked until the
cancellation is complete.
A
B
4 5
3736