socomec ATys C20 - Operation of ATYS C20;C30; Presentation; Operational Modes

Presentation
The product allows:
• sources control,
• automatic transfer control in AUT mode,
• parameters configuration,
• voltage and frequency metering,
• system state display,
• alarm or fault indication,
Controller ATyS
OPERATION
ATyS C20/C30
44
SOCOMEC - Réf.: 532 214 C
Presentation
Operational modes
Programming
Operation
Visualisation
Automatic sequences
7 digits + 14 pointers
LCD
Green led is on when product is
powered
POWER led
RJ45 terminal for
ATyS D10 or D20.
If connected, the
LCD is off
RJ45 connection*
Led is on when product is faulty.
Disconnect power supplies to reset
FAULT led
- Led is on: source = OK
- Led is off: source is not available
Sources state
2 green leds:
- switch I state
- switch II state
Switch state
- Automatic sequence simulator (test on load)
- Genset remote start (test off load)
- Changeover switch position control (local or remote)
Operational modes
Keypad
Escape Navigation
Validation
LCD & leds test
Operations
SOFTWARE VERSION
Displayed after reset.
(3 minutes power off action to allow reset).
Version
number
ATYS 428 A GB
ATYS 427 A GB
* only on ATyS C30.