Why does socomec ATyS C55 Controller display 'Max operation per minutes reached'?
If the Socomec Controller performs 10 operations in under 1 minute, the mode will remain the same. The controller will not perform or allow any operation during a set time. This is automatically cleared after 1 minute, which is configurable through software, and the value is dynamic.
What to do if there is an unexpected transfer on Socomec Controller?
If the Socomec Controller receives unexpected feedback from the switch without sending an order or experiences a loss of feedback from the current position, the mode will remain the same. This can be cleared through the display or the RST - Reset Fault input.
What to do if Socomec Controller failed to transfer?
If the Socomec Controller fails to reach the position after sending an order, or loses feedback from the new source after sending a transfer command, the mode will remain the same and the controller will start retries. The fault is automatically cleared if the requested position is reached, or it can be cleared via the display or the RST - Reset Fault input.
What does external fault mean on socomec ATyS C55 Controller?
If an input selected as FTE - External Fault becomes active on the Socomec Controller, the switch will immediately go to position 0 / center-off without timers, and the mode is set to Partial Inhibit (genset starts if needed). To resolve this, ensure the input is no longer active and perform a reset by user via the RST - Reset Fault input or through the display.
General| Brand | socomec |
|---|---|
| Model | ATyS C55 |
| Category | Controller |
| Language | English |
To Next Page
