What to do if the alarm LED is blinking on my socomec Controller?
If the alarm LED is blinking on your Socomec Controller, make sure that the input 63-64 is closed. Also, verify that a problem hasn't occurred during a transfer order and validate the fault using the AUTO button. Lastly, check if the DIP switches have changed position, and if so, validate the change using the RES button.
How to troubleshoot source LED blinking on socomec Controller?
To troubleshoot blinking source LEDs on your Socomec Controller, verify that the sources are within the voltage range configured through the DIP switch or communication settings. Also, ensure that the sources are cabled correctly and verify the phase rotation.
What to do if sources are not detected on socomec Controller?
If the sources are not being detected on your Socomec Controller, verify that the device is correctly powered on using the power LED. Also, ensure that the DIP switch settings correspond to your installation.
What to do if positions are not detected on socomec Controller?
If positions are not being detected on your Socomec Controller, verify that the position input cabling is correctly done.
General| Brand | socomec |
|---|---|
| Model | ATyS A15 |
| Category | Controller |
| Language | English |
Highlights critical DANGER, WARNING, and CAUTION information for safe operation.
Guides users through the initial mounting steps for the controller.
Illustrates and explains the layout and indicators of the controller's HMI.
Instructions for mounting the ATYS A15 on a door panel.
Instructions for mounting the ATYS A15 on a standard DIN rail.
Describes how the ATYS A15 meters and senses voltage and phase information.
Identifies and describes the various connection terminals on the ATYS A15.
Provides detailed denomination, description, and characteristics for each terminal.
Explains the Auto, Manual, and Inhibit modes of the ATYS A15 controller.
Describes the voltage sensing capabilities for single and three-phase networks.
Explains the control signal outputs to the RTSE for position commands.
Describes the inhibit input function for disabling automatic and manual controls.
Details the inputs that indicate the RTSE's current position.
Guides on configuring the ATYS A15 using its front-panel DIP switches.
Provides solutions for common detection, LED, and parameter issues.
Describes source failure and return timers configuration.
To Next Page
