socomec COUNTIS E00 - 2 Hazards and Warnings; Risk of Electrocution, Burns or Explosion; Risk of Damaging the Unit; Responsibility

4 EN
COUNTIS E00/E02 - 547975A - SOCOMEC
2. HAZARDS AND WARNINGS
The term "device" used in the paragraphs below refers to the COUNTIS E00/E02.
The assembly, use, servicing and maintenance of this equipment must only be carried out by trained, qualied professionals.
SOCOMEC shall not be held responsible for failure to comply with the instructions in this manual.
2.1. Risk of electrocution, burns or explosion
• Only duly authorised and qualied personnel may work or install/uninstall the device.
• The instructions are valid together with the specic instructions for the device.
• The device is designed only for its intended purpose as set out in the instructions.
• Only accessories authorised or recommended by SOCOMEC may be used in association with the device.
• Before proceeding with installation, maintenance, cleaning, disassembly, connection, or maintenance work, the device
and system must be cut off from the mains to avoid electrocution and damaging the system and device.
• This device is not designed to be repaired by the user.
• For any questions related to the disposal of the device, please contact SOCOMEC.
Failure to comply with the instructions of the device and this safety information can cause bodily injury, electric
shock, burns, death or damage to property.
2.2. Risk of damaging the unit
To ensure that the unit operates correctly, make sure that:
• The unit is correctly installed.
• There is a maximum voltage at the voltage input terminals of 276 VAC phase-neutral
• The network frequency indicated on the device is observed: 50 or 60 Hz.
• a maximum current 40 A at the current input terminal.
Failure to respect these precautions could cause damage to the unit.
2.3. Responsibility
• Assembly, connection and use must be carried out in accordance with the installation standards currently in force.
• The unit must be installed in accordance with the rules given in this manual.
• Failure to observe the rules for installing this unit may compromise the device's intrinsic protection.
• The unit must be positioned within an installation which complies with the standards currently in force.
• Any cable which needs to be replaced may only be replaced with a cable having the correct rating.