SR5 MANUAL
10- ADJUSTMENT OF FRONT WHEELS
10.1 ADJUSTMENT OF FRONT TRACKING WIDTH
The adjustment of the front width is realized with several spacers (1 spacer of 15mm, and 3
spacers of 5mm for each stub axle.), and two hubs type (short hub: 60mm or long hub: 80mm).
The wider the front is widened, the harder the steering is hard, and the narrower the front is
narrows, the easier the steering is easy.
DRY TRACK
We advise you to adjust the front with one
spacer of 15mm inside (D=15mm), and
use the short hubs.
D max
If you wish increase the grip of front, it
suffice to increase the width of the front
with spacers.
If you have a front brake, refer to the
chapter MAXIMUM ADJUSTMENT WITH
FRONT BRAKES.
D
WET TRACK
We advise you to adjust the front to the
maximum (1 spacer of 15mm and 3 spacer
of 5mm inside), and use the long hubs.
If you have a front brake, refer to the
chapter MAXIMUM ADJUSTMENT WITH
FRONT BRAKES.
D max
MAXIMUM ADJUSTMENT WITH FRONT BRAKES
If you have the front brake on your
chassis, the adjustment of the front is
limited. Place a maximum of 20mm of
spacers inside. (D max=20mm)
.
- 18 -
To Next Page
Loading...