Sofar solar 1.1K-3.3KTL-G3 - Tools

SOFAR 1.1K~3.3KTL-G3 User manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd
- 15 -
impossible to twist the DC switch from OFF to ON, or ON to OFF. Remove the
screw before turning the DC switch from OFF to ON or ON to OFF.
3.4. Tools
Prepare tools required for installation and electrical connections.
Table 3-3 shows the tools required for installation and electrical connections.
NO.
Tool
Model
Function
1
Hammer drill
Recommend drill
dia. 6mm
Used to drill holes on the wall.
2
Screwdriver
Wiring
3
Cross screwdriver
Remove and install AC terminal
screws
4
Removal tool
Remove PV terminal
5
Wire stripper
Strip wire
6
4mm Allen
Wrench
Turn the screw to connect rear
panel with inverter.
7
Crimping tool
Used to crimp power cables
8
Multi-meter
Used to check grounding
9
Marker
Used to mark signs