Chapter 1 - Introduction
PBpro ETH - User Guide
5
1 Introduction
1.1 About PBpro ETH
Softing's PBpro ETH Remote PROFIBUS interface is a family of interfaces for remote
access up to four PROFIBUS segments via Ethernet for device parameterization,
controller programming and data acquisition.
1.2 Safety precautions
Read this manual before starting.
For damages due to improper connection, implementation or operation
Softing refuses any liability according to our existing guarantee obligations.
Note
Do not open the housing of the PBpro ETH. It does not contain any parts
that need to be maintained or repaired by the user. In the event of a fault or
defect, return the unit to the vendor.
Opening the unit will void the warranty!
CAUTION
This is a Class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to take
adequate measures!
1.3 About this document
1.3.1 Purpose
This document describes the installation and configuration of PBpro ETH by means of a
PBpro ETH with 4 fieldbus connections.
1.3.2 Target group
This document is addressed to technicians which are responsible for installing and
configuring a PBpro ETH in a factory floor environment.
To Next Page
Loading...