Software House RM2-4000-PI26 User Manual

1
RM2-4000-PI26 Reader
RM2L-4000-PI26 Reader
Installation Guide
Version A0
Document Part Number 8200- 1179-01
September 2015
OVERVIEW
This guide provides installation and connection information for RM2-4000-PI26 and
RM2L-4000-PI26 Readers.
NOTE The RM2-4000-PI26 reader model is UL294 approved and not UL1076 approved.
The RM2L-4000-PI26 reader model is both UL294 and UL1076 approved.
Reader Models
The RM readers provide an enclosed RM-4 board with multiple read heads. The readers
include two separate read heads in their enclosure – a multi-technology read head
positioned behind the right hand side of the reader, and a separate Indala prox read head
located behind the keypad portion of the reader. The multi-technology read head will
read both low frequency (125KHz) HID prox cards and high frequency (13.56 MHz)
smart cards.
FIGURE 1. Reader Models
RM2-4000-PI26
RM2L-4000-PI26
DRAFT

Software House RM2-4000-PI26 Specifications

General

Model	RM2-4000-PI26
Buzzer	Yes
Form Factor	Wall Mount
Housing	Polycarbonate
Card Technology	125 kHz Proximity
Operating Humidity	0% to 95% (non-condensing)
Output Format	Wiegand, Clock-and-Data
Tamper Detection	Yes

Summary

Product Introduction and Features

Overview and Reader Models

Provides installation and connection info for RM2-4000-PI26 and RM2L-4000-PI26 readers.

Supported Card Technologies

Details card formats supported by the RM Multi-Technology reader, including 125 KHz.

Smart Card Formats and Features

Lists supported 13.56 MHz smart card formats and key product features.

Controller Communications and Standards

Covers general features, controller communication, and open standards compliance.

Technical Specifications

General Specifications

Details technical specifications for data cable, temperature, and distances.

Reader Power Requirements

Outlines power supply requirements, voltage, and current limits for readers.

Installation Procedures

Reader Mounting Procedures

Step-by-step guide for installing the reader mount plate and housing.

Wiring Reader Components

Illustrates reader connections to the RM-4 board and other system components.

Reader Setup and Configuration

Explains setting reader address switches and RS-485 EOL termination.

Grounding, Shielding, and Termination

Covers proper grounding, shielding practices for reader bus and termination.

Optional Heater Kit Installation

Details installing the optional heater kit for outdoor use in cold environments.

Testing and Maintenance

Reader Testing Procedures

Steps to test reader functionality, voltage, address, and interface.

Configuration Notes and Programming

Notes on default settings, program cards, and reader configuration options.

Firmware Flash Upgrade

Information on upgrading the reader's firmware revision.

Compliance and Safety

Regulatory Compliance Information

Lists various compliance standards including FCC, IC, and regional certifications.

UL Listing and Safety Information

Details UL listing requirements and essential life safety precautions.