SolarEdge SE4000H User Manual

HANDLING AND SAFETY INSTRUCTIONS
During installation, testing and inspection, adherence to all the handling and safety
instructions is mandatory. Failure to do so may result in injury or loss of life and
damage to the equipment.
Safety Symbols Information
The following safety symbols are used in this document. Familiarize yourself with the
symbols and their meaning before installing or operating the system.
WARNING!
Denotes a hazard. It calls attention to a procedure that, if not correctly
performed or adhered to, could result in injury or loss of life. Do not proceed
beyond a warning note until the indicated conditions are fully understood and
met.
CAUTION!
Denotes a hazard. It calls attention to a procedure that, if not correctly
performed or adhered to, could result in damage or destruction of the
product. Do not proceed beyond a caution sign until the indicated conditions
are fully understood and met.
NOTE
Denotes additional information about the current subject.
IMPORTANTSAFETYFEATURE
Denotes information about safety issues.
Disposal requirements under the Waste Electrical and Electronic Equipment (WEEE)
regulations:
NOTE
Discard this product according to local regulations or send it back to SolarEdge.
HANDLING AND SAFETY INSTRUCTIONS 5
EV Charging Single Phase Inverter Guide MAN-01-00583-1.5

SolarEdge SE4000H Specifications

General

Model	SE4000H
Manufacturer	SolarEdge
AC Output Power	4000 W
Rated AC Power	4000 W
Max. AC Power	4000 VA
AC Voltage	240 V
Max. Input DC Voltage	480 Vdc
Dimensions	26.2 x 15.4 x 8.3 in
Weight	44.1 lbs
Cooling	Natural Convection
Protection Rating	IP65
AC Voltage Range	211-264 V
Frequency	60 Hz
Number of MPP Trackers	1
Protection Degree	IP65
Max. Output Current	16.7 A
MPPT Voltage Range	380 - 480 Vdc
Max. DC Input Current	15 A
Operating Temperature Range	-25°C to 60°C
Maximum Efficiency	99%
Max. Efficiency	99%