Installation
33
5.6 Mounting
Step 1: Align the wall mounting bracket horizontally on the wall and mark the
position of the drill holes. Take the height of the stacked battery into account
when mounting the bracket. Observe the bubble of spirit level and adjust the
wall bracket until the bubble stays in the middle.
308 mm
15 mm
284 mm
Step 2: Set the wall bracket aside and drill holes with Ø10 drill bit. The depth
of the holes should be
＞
80 mm. Do cover the inverter before drilling holes
and clean up any dust in and around the holes using dust collector.
hammer drill
Ø10 drill
Depth: >80 mm
Step 3: Insert the expansion bolt into holes and secure the wall bracket to the
wall withexpansion screws.
ST6.0
8-10 N·m
90°
To Next Page
Loading...
