Safety
10
2.3 CE Directives
This section describes the requirements of the European low voltage regula-
tions, including safety instructions and system licensing conditions, the user
must comply with these regulations when installing, operating, and maintain-
ing the inverter, otherwise personal injury or death may occur, and the inverter
will be damaged.
Please read the manual carefully when operating the inverter .If you do not
understand "Danger", "Warning", "Caution" and the description in the manual,
please contact the manufacturer or service agent before installing and operat-
ing the inverter.
Make sure that the whole system complies with the requirements of
EC(2014/35/EU, 2014/30/EU, etc.) before starting the module (i.e. to start the
operation).
Standard of 2014/35/EU (LVD)
EN IEC 62109-1; EN IEC 62109-2
EN 62477-1
Standard of 2014/30/EU (EMC)
EN IEC 61000-6-1; EN IEC 61000-6-2;
EN IEC 61000-6-3; EN IEC 61000-6-4;
EN IEC 61000-3-2; EN 61000-3-3;
EN IEC 61000-3-11; EN 61000-3-12
EN 55011
The assembly shall be installed in accordance with the statutory wiring rules.
Install and congure the system in accordance with safety rules, including the
use of specied wiring methods. The installation of the system can only be
done by professional assemblers who are familiar with safety requirements
and EMC. The assembler shall ensure that the system complies with the rel-
evant national laws. The individual subassembly of the system shall be inter-
connected by means of the wiring methods outlined in national/international
such as the national electric code (NFPA) No. 70 or VDE regulation 4105.
To Next Page
Loading...
