e) Feed in energy
The feed-in energy contains the energy exported to the grid by today, this
month and total.
>Load 1 consume
Load 2 consume
Load consume
d) Load consume
The Load consume contains the energy consumed by specific loads by
today, this month and total.
>Today:
00.0KWH
Feed-in Energy
g) Error Logs
The Error logs record the lastest six error messages happened.
>No error
Error log
Ø
Setting
Setting
Date Time
Advanced
Language
Ethernet
need password
On-grid
User-define
Battery
Reset
Safety
Power Factor
Grid
Export Control
Remote Control
Phase Power Balance
Charger
EPS
Reset Inv Energy
Reset Meter Energy
Reset Load
Factory Reset
Config Guide
Work Mode
Relay Control
New Password
Reset Errorlog
● Setting
This function is used for setting of the inverter time, connection, battery
,grid and so on.
Enduser can set Date Time, Language and Ethernet directly.
But for advance setting, it requires installer password to operate most of the
professional settings.
Date Time
Language
Ethernet
Settings
(a)
(b)
(d)
c)(
(d-1)
(d-2)
(d-3)
(d-4)
(d-1-1)
(d-1-2)
(d-1-3)
(d-1-4)
(d-1-5)
(d-1-6)
(d-1-8)
(d-2-1)
(d-2-2)
(d-3-1)
(d-3-2)
(d-3-3)
(d-3-4)
(d-3-5)
(d-3-6)
(d-4-1)
(d-4-2)
(d-4-3)
Self Test
(d-1-7)
Grid Service
Setting Setting
50
51
>Today:
00.0KWH
EPS Yield
c) EPS Yield
The EPS Yield function contains charger yield for today, yesterday ,this
month ,last month and total.
>GridModeRunTime
80.3H
System RunTime
f ) System RunTime
This function contains grid mode run time and EPS mode run time.
To Next Page
Loading...
Need help?
General
