b) Language
This inverter provides several languages for customer to select.
a) Date Time
This interface is for user to set the system date and time.
2013 ->06 <-06
10:19
Date time
English
Deutsch
Language
c) Ethernet
There are two modes to obtain IP address: static and DHCP.
User can set the information about ethernet such as IP address, subnet mask
number and default gateway number and Mac sdress.
> IP Method
static
Ethernet
d) Advanced
All the advance setting can be set here, such as battery, grid, EPS and so on.
“Advanced” is divided four parts: On-grid, Battery, Reset, User-define. And every
part has lower level parts.
Pls contact with your installer or factory for the installer password to enter.
On-grid
Battery
Reset
Advanced
d-1-1) Safety
User can set safety standard according to different countries and grid tied
stanndards.There are 8 standards to select. (May change without notice)
Item
7
1
2
3
4
5
6
8
Country
VDE 0126
ARN 4105
German
AS 4777
Australia
G83/2
UK
EN 50438_NL
Netherland
CEI 0-21
Italy
IEC61727_In
India
Standard
German
G59/3
UK
d-1-2) Power Factor ( For specific country if required by the local grid.)
There are 5 modes for selecting: Off , Under-Excited, Over-Excited, Curve, Q( u ).
Mode Comment
Off
Over-Excited
Fixed Q Power
PF value
Q Power
Under-Excited PF value
Curve
Upper limit
Lower limit
Power Upper
Power Lower
PFLockInPoint ( CEI 0-21 only)
PFLockOutPoint ( CEI 0-21 only)
Q( u )
QuVupRate
QuVlowRate
-
( EN50438_NL only)
( EN50438_NL only)
Setting Setting
52
53
On-grid
Safety
Power Factor
Grid
Export Control
Remote Control
Phase Power Balance
(d-1)
(d-1-1)
(d-1-2)
(d-1-3)
(d-1-4)
(d-1-5)
(d-1-6)
(d-1-8)
Self Test
(d-1-7)
Grid Service
To Next Page
Loading...
Need help?
General
