Solcon TPR-6 - Service Mode

19 • Mode Pages Display
________________________________________________________________________________________________
6.6 Service Mode
Press PAGE and ▼simultaneously, the following will display:
Press SELECT
If test was OK the display will show for a short time
If test failed the display will show
Press SELECT
Displaying the software date (04.03.04) and version.
Press SELECT
If it is required to return to default setting (original factory setting) press STORE & PAGE keys simultaneously
(Note: All values set by you will be erased).
Display will show:
Press SELECT
If it is required to reset all STATISTICAL DATA press STORE & RESET keys simultaneously.
(Note: All data in STATISTICAL DATA will be erased).
*** SERVICE ***
*** OPTIONS ***
RUN SELF TEST ?
PRESS “ VALUE-UP”
SELF TEST PASSED
SELF TEST FAILED
ERROR CODE = 32
PROGRAM VERSION
TPR040304-MB-ENG
STORE NOW ?
DEFAULT SETTINGS
DATA SAVED OK
CLEAR
STATISTICAL DATA
Attention !
The last two actions (store DEFAULT SETTINGS and clearing STATISTICAL DATA in SERVICE
MODE page) should be done with care, since it is not possible to retrieve the previous set point
parameters or statistical data.