23 • Flash Messages
________________________________________________________________________________________________
10. FLASH MESSAGES
The message is displayed for a short while only. Display than returns to the previous message. Flash
messages are usually displayed as a response to an operator action.
It is used either to confirm activation of the requested operation, or to indicate reason for not doing so.
Flash messages are :
Displayed after pressing Store key. If an error is found during store
process, then next message is shown.
Displayed when an error is found in the store process.
Displayed after power-up, if the non-volatile parameter check sum is
found to be wrong.
When Authorized Key is open (locked), and a parameter change is
attempted. Also displayed after Unauthorized Store and Reset action.
Displayed as a response to running the built in test procedure,
provided that all tests were "O.K.".
SELF TEST FAILED
ERROR CODE = 32
Displayed as a response to finding an error during the operation of
Test procedure.
Error code should be reported to Authorized Factory representative.
To Next Page
Loading...
General