Solectek skyway - Page 49

49
radius_server RW 10.20.20.3 set radius_server [server_ipaddr]
show radius_server
Base Station only. Sets Radius
Server IP address
radius_timer RW 86400
set
radius_timer
[period]
show radius_timer
Base Station only
Set Radius reauthentication period,
in Seconds
radius_user RW wpa1@host.loc
al
set
radius_user
[name]
show radius_user
Client Unit only
Set Radius client user name
reboot W
reboot
Reboot system
rfnetname RW NAME_1
set
rfnetname
[netname]
show rfnetname
Set RF Network Name
rmod RW set rmod [macaddr] [streams] [bpsk-1/2 |
qpsk-1/2 | qpsk-3/4 | qam16-1/2 | qam16-
3/4 | qam64-2/3 | qam64-3/4| AUTO]
Set Remote Modulation/Streams
on
route R
show
route
Show IP route table
rssi R
show
rssi
Show Local Recv Signal Strength
savecfg W
savecfg
Save configuration to permanent
memory
serialnum R
show
serialnum
Show system serial number
set R
set ?
Set ? for commands
show R
show
Show commands
snmp RW enabled
public – for all
strings
192.168.1.1 for
trap manager
set snmp enable=[yes|no]
set snmp [read-community|rc]=[abcdef]
set snmp [trap-community|tc]=[abcdef]
set snmp [trap-manager|tm]=[a.b.c.d]
show snmp
Set SNMP configuration
parameters
status R
status
Show system status
streams RW 1
show streams
set streams [1 | 2]
Show / Set the number of MIMO
data streams. Limited to 1 for
Access 50.
sysmode RW retains
sysmode
show sysmode
set sysmode [MULTIPOINT_MASTER |
MULTIPOINT_SLAVE]
Show / Set the MULTIPOINT
operating mode
tz RW “+00:00”
tz
[+hh:mm |
-
hh:mm]
Set/Show time zone