16
Settings Mode & Factory Reset
This section will detail how to enter Fusion's Settings Mode and the functionality that can be changed. It also details how to reset
Fusion back to a factory default state.
Entering Settings Mode
To enter the Settings Mode, switch the unit on then hold down the TRANSFORMER and BYPASS switches during the startup LED
sequence. In this mode it is possible to modify some parameters of the unit. These parameters will be recalled each time the unit
is rebooted.
Brightness
Whilst in Settings Mode, it is possible to select five levels of brightness for the meters and switches.
➤ To decrease the brightness, press the VINTAGE DRIVE IN switch.
➤ To increase the brightness, press the VIOLET EQ IN switch.
If the VINTAGE DRIVE IN switch is not lit, minimum brightness is reached. If the VIOLET EQ switch is not lit, maximum brightness
is reached. Factory setting: maximum brightness.
Note: The brightness setting does not affect the startup LED sequence, or signal indicator LEDs found in the
VINTAGE DRIVE and HF COMPRESSOR sections.
Relay Feedback
Whilst in Settings Mode, it is possible to enable or disable the relay feedback of the switches. This affects the startup sequence
and normal operation. To switch between enabled and disabled, press the INSERT IN switch.
➤ If INSERT is dimly lit white, relay feedback is disabled.
➤ If INSERT is lit blue, relay feedback is enabled (a quick relay transition is reproduced as confirmation of the setting).
Factory setting: relay feedback enabled.
Exiting Settings Mode
To exit Settings Mode, press and hold the BYPASS switch until the unit reboots.
+ +
To Next Page
Loading...
Need help?
General
