SOLINTEG ECA-B Series - Inspection after Installation

25
User Manual
ECA-B Series
4.2.4 Inspection after Installation
① Handle all shipping and packaging materials in accordance with local laws and regula-
tions;
② Remove the rubbish and debris around the charger. Do not leave tools on site or in the
charger;
③ Clean the charger with an anti-static cloth and remove the dust on the suace;
④ Check whether the base is secure and sealed;
⑤ Check whether the pas inside the device are xed reliably;
⑥ Use a multi-meter to check whether the electrical connection and wiring are correct,
complete and secure;
⑦ Check whether the protection level of device meets the requirements, especially the ca-
ble inlet at the bottom of charger;
⑧ Check the appearance, marking, completeness and cleanliness;
⑨ After checking, reinstall the charging connector holder, tighten the screws, cover the
decorative cover, and inse the charging connector into the connector holder like shown
as below.
EVC
EVC