User’s manual SOLIS MASTER 5000
53
Note: If the brewing unit is incorrectly
positioned, the multiple control indicator
(21) will be lit and the machine will be
blocked.
9.1 For descaling it is recommended
to use the specially suitable descaling
agent SOLIPOL.
9.2 Switch off the appliance. Put the
descaling solution in a ratio of 1:1 (0,5
litres of SOLIPOL and 0,5 litres of water)
into the water reservoir. Place reser-
voir on machine.
9.3 Put large container under the
steam and hot water nozzle and open
steam/hot water knob. Switch on
main ON/OFF switch and drain
approx. 3 dl of water through the
nozzle.
9.4 Switch off main ON/OFF switch
and allow the descaling solution to work
for approx. 5 minutes.
9.5 Repeat the procedure as per Pt.
9.3 and 9.4 two or three times until all
the descaling solution has been drained
from the water reservoir. Close the
steam/hot water knob. Carefully rinse
the water reservoir and refill with
fresh water.
9.6 Switch on main ON/OFF switch
and carefully rinse the machine by
draining the fresh water (at least one
liter) through the steam and hot water
nozzle. Careful rinsing will avoid any
negative influence on the taste of your
coffee. The SOLIS MASTER 5000 is
now again ready for operation.
Important: Regular descaling will pro-
tect your machine from costly repairs.
Any damage due to a lack of regular
descaling, incorrect operation or non-
compliance with this user’s manual are
not covered by warranty. Under no cir-
cumstances is vinegar to be used for
descaling since this will damage the
machine.
9.0 Descaling
Depending on the hardness of the water (even if a water filter
is used), the machine must be descaled regularly, latest every
4–6 months. In areas with specially hard water, descaling will
be necessary more often.
To Next Page
Loading...
Need help?
General
