6. Operation6. Operation
Maintenance or replacement could clear or cause a different value of total energy. Use this
function could allow user to revise the value of total energy to the same value as before. If
the monitoring website is used the data will be synchronous with this setting automatically.
(see Figure 6.19).
Press the DOWN key to move the cursor, Press the UP key to revise the value. Press the
ENTER key to execute the setting. Press the ESC key to return to the previous menu.
6.5.6 Calibrate Energy
Figure 6.19 Calibrate energy
YES=<ENT> NO=<ESC>
Energy:0000000kWh
.33..32.
6.5.7 AUS STD. Settings
This sub menu is enabled when the grid standard is set to A S4777. To comply with New A US/
NZ 4777.2, Ginlong Solis 4G inverter could set different work mode to work with different
grid requirement.
There are 5 work mode in working mode submenu.
1. Fixed PF 2. Reac. Power 3. Power-PF 4. Volt-Watt 5. Volt-Var.
There are 4 setting under AUS S TD settings.
1. Working mode 2. Power Rate limit 3. Freq. Derate set 4. 10mins OV-G-V set.
1. Fixed PF
Set PF (-0.8, +0.8), Default 1, Resolution 0.01
2. Reac. Power
Set reacive power (0, 60%), Default 0, Resolution 1%
The parameter in each model could be set as below:
4. Volt-Watt
Set Voltage1: 207-220V, Default 207V
Set P_Limit1: 20%-100%, Default 100%
Set Voltage2: 216-230V, Default 220V
Set P_Limit2: 20%-100%, Default 100%
Set Voltage3: 235-255V, Default 250V
Set P_Limit3: 20%-100%, Default 100%
Set Voltage4: 244-265V, Default 255V
Set P_Limit4: 20%-100%, Default 100%
5. Volt-Var
Set Voltage1: 207-220V, Default 207V
Set Voltage2: 216-230V, Default 220V
Set Voltage3: 235-255V, Default 250V
Set Voltage4: 244-265V, Default 255V
Set Leading: 0~+60%, Default +30%
Set Lagging: 0~-60%, Default -30%
3. Power-PF
Set Pb_Limit: 0-100%, Default 25%
Pc_Limit: 0-100%, Default 50%
Pc_Factor: (-0.8, +0.8), Default -0.95
To Next Page
Loading...
