Starting engine / stopping engine
ENGLISH 13
The following hints serve to extend the service
life of the starter rope and the starter
mechanism:
• Always pull up the starter rope in a straight
line.
• Do not let the rope rub against the edge of
the rope eyelet to prevent fraying.
• Do not pull out the rope over its full length
to prevent breakage.
• Guide the starter handle to its initial position
rather then letting the handle slam against
the starter housing.
A damaged starter rope can be replaced by a
service specialist.
8.3 Engine will not start
If the engine fails to start despite several
starting attempts, check all previously described
adjustments and settings and try to start the
engine again. If the engine still fails to start, the
combustion chamber in the cylinder is likely to
be flooded.
In that case we recommend to proceed as
follows:
• Remove spark plug cover.
• Pull spark plug cap from spark plug.
• Remove spark plug and dry fuel mixture from
electrodes.
• Move throttle lever upwards to full throttle
position. Pull starter handle several times
(with removed spark plug) to clear
combustion chamber.
• Move throttle lever downwards to idling
position, refit spark plug, plug cap and plug
cover.
• Start engine with choke lever (Fig. 6.1.) in
downward (off) position.
8.4 Stopping engine:
Press stop button (9) until the engine stops.
Fig. 9
To Next Page
Loading...
