User Manual
SolwaveOvens.com 13
Programming the Oven Controls
Programming Keys
Oven is shipped from the factory for single key program-
ming. To change the oven default to allow double key
programming, see User Option section. To change the
amount of time or the power level for a preset key:
1. Open oven door.
• READY displays.
• If door is closed or STOP key is pressed before
programming is complete, changes are discarded
and microwave exits programming mode.
2. Press and hold key 1 for approximately 5 seconds.
• This begins programming mode.
• Microwave will beep and PROGRAM displays.
• Oven is in programming mode.
3. Press key to be reprogrammed.
• Press two keys if reprogramming a double
pad program.
• Power level and cooking time display.
• If power level does not display, microwave is
set to full power.
4. Enter cooking time by using the number keys.
5. Press a power level key to change power level
if desired.
6. Press START key to save new programming
changes to the key.
• PROGRAM displays.
• If START is not pressed, changes will not
be saved.
7. Press STOP/RESET key or close oven door to exit
programming mode.
Canceling Mistakes
• If oven is not cooking, press STOP/RESET key to
clear display.
• If oven is cooking, press STOP/RESET key once to
stop oven, then again to clear display.
• If oven door is open and time shows in display,
close oven door and press STOP/RESET key to
clear display.
Programming Multiple Stages
Stage cooking allows consecutive cooking cycles
without interruption. Up to four different cooking cycles
can be programmed into a memory key. To use
stage cooking:
1. Follow steps 1 through 5 above.
2. Press TIME ENTRY key.
• Display briefly shows the key number that is
being programmed and the stage number to
the upper right.
• Display changes to cook time and power level
for the next stage.
3. Enter cook time and power level as in steps 4 and 5
above.
• To enter another cooking stage for that key,
press TIME ENTRY key again.
• Up to four different stages can be programmed.
4. Press START key to save new programming
changes to the key.
5. Press STOP/RESET key or close oven door to exit
programming mode.
QTY X2 Programming
This feature allows a preset percentage of original cook
time, called a cooking factor, to be added to a cook
sequence. To change the cooking factor:
1. Open oven door.
2. Press and hold key 1 for approximately 5 seconds.
3. Press key to be reprogrammed.
4. Press the QTY X2 key.
5. Press a numbered key to change the cooking factor.
• Cooking factor can be set from 10% to 100%.
• Default is 80%.
• Key 5 would change the cooking factor to 50%.
• Key 3 would change the cooking factor to 30%.
6. Press START key to save changes.
To Next Page
Loading...
