User Manual
6 SolwaveOvens.com
Grounding
WARNING
To avoid risk of electrical shock or death, this oven must be grounded and plug
must not be altered.
• Oven MUST be grounded. Grounding reduces risk of electric shock by providing an escape wire for the electric
current if an electrical short occurs.
• This oven is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded. Consult a qualified electrician or servicer if grounding instructions are
not completely understood, or if doubt exists as to whether the oven is properly grounded.
• Do NOT use an extension cord. If the product power cord is too short, have a qualified electrician install a three-slot
receptacle.
• This oven should be plugged into a separate circuit with the electrical rating as provided in product specifications
(available on Solwave’s website at www.SolwaveOvens.com). and the oven’s serial plate / rating label. When the
oven is on a circuit with other equipment, an increase in cooking times may be required and fuses can be blown.
External Equipotential Earthing Terminal (Export Only)
• Equipment has secondary earthing terminal. Terminal provides external earthing connection used in
addition to earthing prong on plug. Located on outside of oven back, terminal is marked with symbol
shown at right.
Installation
WARNING
Excessive Weight Hazard - Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
Unpacking the Oven
• Inspect oven for damage such as dents in door or
inside oven cavity.
• Report any dents or breakage to source of purchase
immediately.
• DO NOT attempt to use oven if damaged.
• Remove all packing materials from oven interior.
• If oven has been stored in extremely cold area, wait
a few hours before connecting power.
• A protective film is used to prevent scratching of the
outer case during transportation. Peel off the film
from the exterior of the oven before installation.
• The warning label provided with the oven must be
placed in an easily visible location near the oven.
Radio Interference
Microwave operation may cause interference to WiFi
network, radio, television, or a similar oven. Reduce or
eliminate interference by doing the following:
• Clean door and sealing surfaces of oven according
to provided instructions.
• Place WiFi network, radio, television, etc. as far as
possible from oven.
• Use a properly installed antenna on radio, television,
etc. to obtain stronger signal reception.
To Next Page
Loading...
