User Manual
22 SolwaveOvens.com
Troubleshooting
WARNING
To avoid electrical shock which can cause severe personal injury or death, DO NOT
remove outer case at any time.
Only an authorized servicer should remove outer case.
SYMPTOM POSSIBLE CAUSE SOLUTION
Oven fan runs and light
remains on after cook
cycle has completed.
Normal operation.
The fan cools oven components, it is normal for
the fan to run for 60 seconds after cook cycle is
complete.
Oven fan runs while
oven is not cooking.
Oven does not operate.
Oven is unplugged. Confirm oven is plugged in to appropriate outlet.
Fuse has blown. Check fuse and/or circuit breaker.
Oven is plugged in to unqualified outlet.
Confirm oven is plugged in to dedicated,
grounded circuit that matches information on
serial plate.
Contact electrician to confirm.
Oven does not accept
entries when keypad is
pressed.
Oven is turned off. Confirm oven is plugged in and turned on.
Oven door is ajar or was not closed
properly.
Open and close oven door, try pressing keypad
again.
Oven malfunctions or
shows "F" with a number.
Self-diagnostic system has detected an
error or problem.
Record the number shown. Unplug the oven
and wait for 1 minute before plugging back in.
If failure continues, call for service.
Oven operates
intermittently.
Possible blockage of airflow.
Check air filters and discharge area for
obstructions, clean as directed in Cleaning and
Maintenance section.
Oven operates, but does
not heat food.
Possible oven failure.
Place one cup of cool water in oven. Heat for
1 minute. If temperature does not rise, oven is
operating incorrectly and servicer should be
called.
"Clean Filter" displays. Normal operation.
Standard alert that will appear for 24 hours as a
notification that it is time to clean the filter.
To Previous Page
Loading...
