User Manual
SolwaveOvens.com 7
Oven Placement
• Do NOT install oven next to or above source of heat, such as pizza oven or deep fat fryer. This could cause oven to
operate improperly and could shorten life of electrical parts. Ambient temperatures above 90°F may cause damage
to the unit.
• Do NOT block or obstruct oven filters. Allow access for cleaning.
• Install oven on level counter-top surface.
• Outlet should be located so that plug is accessible when oven is in place.
• This oven is required to be sealed to the countertop to establish proper sanitary operation. It is manufactured with a
basepan gasket designed to provide this seal.
• Inspect gasket for damage before placing oven on countertop.
• Minimize sliding of oven to prevent damage to gasket.
• When in place, this gasket is intended to prevent liquid spillage on adjacent countertop surfaces from passing under
inaccessible portions off the equipment.
Oven Stacking
• Oven stacking is allowed using stacking bracket located on the top of the back panel on the hinge side corner.
• Remove screws from stacking brackets on the rear of the ovens and reattach them to the back panel between both
ovens, securing them together using back panel screws.
Oven Clearances
• Proper air flow around oven cools electrical components. With restricted air flow, oven may not operate properly and
life of electrical parts is reduced.
Minimum Clearances
(stacked and unstacked units)
• 2" (5.1 cm) above top of oven.
• 2" (5.1 cm) around back of oven.
• 1" (2.54 cm) around sides of oven.
• 36" (91.5 cm) above the floor.
1" 1"
2"
2"
36"
2"
To Next Page
Loading...
