18
PROGRAM THE REMOTE
IMPORTANT On each of the following steps, be sure to read the entire step before performing it.
6a. The remote control has three buttons: UP , DOWN , and “MY” . To program the remote, press the UP and DOWN buttons
simultaneously. The blind slats will briefly tilt up and down to acknowledge communication between motor and remote control.
Brief tilt
up & down
6b. Test that the remote is properly communicating to the blind by pressing and holding the UP button ; the blind slats should tilt upward.
If the blind slats move (tilt) downward, press and hold the MY button
until slats briefly tilt up and down. Blinds slats should now move up
when pressing and holding the UP button
.
Brief tilt
up & down
To Next Page
Loading...
