64
© 2013 Somfy SAS. All rights reserved. 06/2013
EN
4. INSTALLATION
Screw the 2 adaptors (1) using 2 M3x8 bolts (2) on the
motor shaft.
Tightening torque = 1,35 N.m +/- 20%
Ensure that the J4 io plate cable does not pass over
a rotating part of the motor or mechanism.
If necessary, compress the edge of the head rail (4) into
the motor zone.
Insert the motor into the head rail (4).
Using the clips (5), attach the motor in the head rail (4)
above the acoustic tapes (6a).
The shaft can be fitted into the adapter using a headless
screw (7).
Tightening torque = 2 N.m maximum
Installation with external clips
Screw the 2 adaptors (1) using 2 M3x8 bolts (2) on the
motor shaft.
Tightening torque = 1,35 N.m +/- 20%
Ensure that the J4 io plate cable does not pass over
a rotating part of the motor or mechanism.
Insert the motor into the head rail (4).
Using the clips (5), attach the motor in the head rail (4)
above the acoustic tapes (6a).
The shaft can be fitted into the adapter using a
headless screw (7).
Tightening torque = 2 N.m maximum
5
4
7
7
4
4.1 57 X 51 mm or 58 x 56 mm head rail, open below
4.2 58 x 56 mm head rail, open above
2
7
1
1
7
2
6a
2
7
1
1
7
2
7
5
4
7
6a
5
5
To Next Page
Loading...
