6
EN
Copyright © 2006-2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved. Images are not contractually binding.
2) Check the direction of rotation; if this is correct,
move on to step 3). If the direction of rotation is
not correct, press the “my” button until the blind
movesbriey(2s).
3) Position the blind at the lower end limit using the
transmitter's up and down buttons.
4) Simultaneously press the transmitter's “my” and
up buttons; the blind is lowered and the lower end
limit is set.
5) Press the “my” button to stop the blind.
6) Press the “my”buttonuntiltheblindmovesbriey
(2 s): the end limit is memorised.
7) Press the “PROG” button on the transmitter
briey:theblindmovesbriey;thetransmitter is
memorised.
The blind is operating in one-touch mode: briey
pressing the up or down button raises or lowers it
completely.
2.3.7. Adjusting the manual upper and automatic
lower end limits
1) Simultaneously press the Up and Down buttons:
theblindmovesbriey.
2) Check the direction of rotation; if this is correct,
move on to step 3). If the direction of rotation is
not correct, press the “my” button until the blind
movesbriey(2s).
3) Position the blind at the lower end limit using the
transmitter's up and down buttons.
4) Simultaneously press the transmitter's “my” and
down buttons; the blind is lowered and the upper
end limit is set.
5) Press the “my” button to stop the blind.
6) Press the “my”buttonuntiltheblindmovesbriey
(2 s): the end limit is memorised.
7) Press the “PROG” button on the transmitter
briey:theblindmovesbriey;thetransmitter is
memorised.
The blind is operating in one-touch mode: briey
pressing the up or down button raises or lowers it
completely.
6)
7)
3)
3)
2)
3)
4) 5)
1)
3)
[4]
3)
2)
3)
4) 5)
6)
7)