Page 8 WWAN PC Card Setup
If your WWAN PC card is already registered and activated with
your service provider and you are able to access the Internet
through your PC using this card, you may skip this section and
continue to
Registering Your Appliance - page 11.
WWAN PC Card Setup
Complete the following steps to set up and provision your
WWAN PC card. Before continuing, verify that your WWAN PC
card and service provider are supported by the SonicWALL
NSA 240 appliance by visiting the SonicWALL website:
<http://www.sonicwall.com/us/tz190cards.html>
Alert: DO NOT insert your PC card into the computer until
you have completed the setup process for your card as
described in this section and successfully accessed
the Internet through your PC using the PC card.
If you are using a GSM-based WWAN service provider, you
may be required to remove the PIN protection from your SIM
chip before using it with the SonicWALL. Please contact your
WWAN service provider for more information on setup and PIN
removal procedures.
Installing PC Card Software
This section covers prerequisites necessary to set up most
WWAN PC cards to work with the NSA 240. Using an available
desktop or laptop PC with Type II PC card slot, complete the
following steps:
1. Install the software that came bundled with your WWAN
PC card before activating the card.
2. When prompted, insert the WWAN PC card into an
available Type II PC card slot on the Laptop or Desktop
PC you are using for card configuration.
3. Install updates to your WWAN PC card, if available.
4. Activate your PC card, if required.
To Next Page
Loading...
