What to do if my Sonoro Radio has no sound?
If your Sonoro Radio has no sound, first, check that the volume isn't set to the minimum and increase it if necessary. Also, make sure that headphones are not connected to the device. Finally, verify that the correct mode is selected.
How to fix Sonoro iElements when it does not switch on?
If your Sonoro Radio doesn't switch on, the most likely cause is that the mains adapter is not correctly connected. Ensure the mains adapter is properly connected.
Why is the alarm not working on my Sonoro Radio?
If the alarm on your Sonoro Radio isn't working, first ensure that the alarm is switched on. Also, check that the alarm volume isn't set to the minimum and increase it if needed. Lastly, make sure headphones are not connected, as this will prevent the alarm from sounding through the speakers.
How to improve poor FM reception on Sonoro iElements?
If you are experiencing poor FM reception quality on your Sonoro Radio, it could be due to a few reasons. The station signal might be too weak for the internal antenna, in which case you should connect the external FM antenna. Also, check that the antenna selection switch is in the correct position. Finally, try changing the position of the FM antenna to improve reception.
What to do if my Sonoro iElements Radio has poor AM reception?
If you're getting poor AM reception quality on your Sonoro Radio, it might be because the AM antenna is not connected. Ensure the AM antenna is properly connected. If it is connected, try changing the position of the AM antenna to see if that improves the reception.
Explains symbols used for safety warnings and tips.
Provides safety instructions for supervising children and individuals with limited faculties.
Outlines safety guidelines for handling and disposing of batteries to prevent hazards.
Details the steps for connecting the mains adapter and power supply safely.
Identifies and explains the controls and displays on the front of the device.
Identifies and explains the connections and features on the rear of the device.
Explains how to turn the device on using the touch sensor and initial features.
Details the procedure for turning the device off by touching and holding the power sensor.
Explains how to set up the alarm function, including wake-up sources and snooze.
Reconfirms connection of the mains adapter and compliance with safety instructions.
To Next Page
General
