Sonoro iElements - Alarm; Automatic switch-off

English
19
8.2 Alarm
Your iElements can wake you up with a radio station or a pleasant alarm tone. You can set
thevolumeofthealarmandusetheso-calledsnoozefunction.
You can set the alarm when the iElements is switched on as well as when the device is
switchedoff.Inbothcasespressthemenubuttonandthenusethe<<and>>buttonsto
navigate through the options until ALARMappearsonthedisplay.Conrmyourselectionby
pressingthemenubutton.
Now you can activate the alarm (ALM ON)ordeactivateit(ALM OFF)withthe+and–
buttonsandconrmyourselectionwiththemenubutton.IfyouselectALM OFF, the setting is
cancelled.Youcanrecogniseanactivealarmbythesmallalarmsymbolonthedisplay.
When you have selected ALM ON, you can set the wake-up time. This is selected in the same
wayassettingthedisplaytimewiththe+/-and<</>>buttons.Conrmyourselectionwith
themenubutton.
SOURCEthenappearsonthedisplayandyoucandecidewhichsignalyouwouldliketobe
wokenby.ThefrequencyrangesFM and AM as well as an alarm tone (BEEP)areavailable.
Makeyourselectionwiththe<<and>>buttonsandconrmitwiththemenubutton.Ifyou
select a radio station, you can use the stations you have saved in the presets. Use the + and
-buttonstoselectfromthe10memorypresets0…9foreachfrequencyband.
VOLUME then appears on the display and you can select the alarm volume of your signal
sourcewiththe+and–buttons.Assoonasthealarmstarts,thevolumeisslowlyincreased
untilitreachesthelevelyouhaveselected.Whenyouconrmyourselectionwiththemenu
button,thealarmhasbeenset.ALARM ON appears on the display.
NOTE!
When setting the alarm time, please pay attention to the selected time format.
Youcanrecogniseanactivealarmbythealarmsymbolonthedisplay.Before
usingthisfunctionforthersttime,testthedifferentalarmvolumestonda
levelthatissuitableforyou.Ifyouhaveconnectedadevicetothe
headphonessocket,pleasenotethatthealarmtonewillonlybeoutput
throughthisdevice.Thismeans,forexample,thatyoumaynotbeableto
hear the alarm if the headphones have slipped. Please make sure that you
switch off the alarm, for example, if you go on holiday.
Youcanswitchoffanactivealarmbypressingthemenubuttonforapproximatelytwo
seconds.Thealarmwillstopandthesmallalarmsymbolonthedisplaystopsashing.
If you want to temporarily suppress an active alarm rather than turning it off, you can use the
snoozefunction.Brieypressthemenubuttononcewhenthealarmisactivated.SNOOZE
thenappearsonthedisplayandyoucanusethe+and–buttonstosetthenumberof
minutesafterwhichthealarmshouldbeswitchedonagain.Thedefaultsettingis5minutes.
Onceyouhavemadeyourselection,pleaseconrmitwiththemenubutton.Thesmallalarm
symbolonthedisplaycontinuestoashandisreactivatedafterthetimeyouhaveset.Ifyou