Sonoro iElements - Basic Function Settings; Switching the device on; Switching the device off; Volume

16
6. Setting the basic functions
6.1 Switching the device on
Touch the symbolonthefrontofthedevice.YouriElementsisequippedwithatouch
sensoratthispoint.Thatmeansthatalighttouchissufcient.Afteritisswitchedon,the
mostrecentlyusedmusicmode(FMradio,AMradio,iPod,Aux)isactivated,themusicslowly
fades in and the LED illuminated ring feature is activated.
NOTE!
You can deactivate the LED illuminated ring feature in the settings of your
iElements. Refer to section 8.6 for details. Your iElements can also switch on
automatically. Refer to section 8.2 for information on using the alarm function.
6.2 Switching the device off
Touch and hold onthefrontofthedeviceabouttwosecondstoswitchoffyourdevice.
GOOD-BYEappearsonthedisplay,followedbythetime,andthecontrolslightingisslowly
turned off.
NOTE!
Your iElements can also switch off automatically after a certain time. Refer to
section 8.3 for information on using the automatic switch-off feature.
6.3 Volume
When the device is switched on, you can increase the volume of your iElements with the +
buttonandloweritwiththe–button.Thedisplayshowstheselectedvolume.Youcansetthe
volumefromVOLMIN(mute)toVOLMAXin30stages.
DANGER!
Never use your iElements at an excessively high volume level. If you listen to
the device at an excessively high volume for long periods of time, you endanger
your hearing. Also refer to the safety instructions in section 2.