Sonoro iElements - Selecting a preset station; Device Settings and Customization; Time

18
NOTE!
Your iElements has an integrated memory so that your stations will remain
saved even if you disconnect the device from the power supply.
7.4 Selecting a preset station
YouriElementscansaveupto10stationsperfrequencybandinthepresetmemory.
If you would like to listen to a preset station, switch on your iElements, select the desired
frequencybandbypressingthe
symbolandactivatethemenuwiththemenubutton.
The MEM CALLfunctionappearsonthedisplayandwhenyouhaveagainconrmedyour
selectionwiththemenubutton,youcanselectoneofthememorypresetsP 0 to P 9 with the
+and–buttons.Theassignedstationfrequencyisdisplayedbehindthememorypreset.
Ifthememorypresethasnotyetbeenassigned,themessageFREE is then displayed.
When you have selected the station you would like to listen to, your iElements plays the
saved station.
Ifyouwouldliketocanceltheselectionofastation,simplydonotpressanybuttonfor
approx.5seconds.YouriElementsthenreturnsfromthemenutoregularplaybackmode.
NOTE!
YouriElementsleavestheworkswithoutanypresetstations.Forthisreasonall
presets are marked as FREE.
8. Settings
8.1 Time
IfyouriElementsisswitchedofforifyouhavenotpressedabuttonforaprolongedperiodof
time when it is switched on, the time is shown on the display. You can have the time
displayedina24hourformat(e.g.21:20)orina12hourformat(e.g.9:20pm).
Tosetthetime,switchoffyouriElements.Pressthemenubuttononce,selectthetimemenu
itemwiththe<<and>>buttonsandconrmyourselectionwiththemenubutton.Youthen
havetheoptionofselectingeitherthe24hourformat(24HR)orthe12hourformat(12HR)
withthe+and–buttons.
Afteryouhaveconrmedyourselectionwiththemenubutton,youcanswitchbetweenthe
settingsofhoursandminuteswiththe<<and>>buttons(theselectionashes)andsetthe
correctvalueswiththe+and–buttons.Finallyconrmyourselectionbypressingthemenu
buttonagain.
NOTE!
AM means “ante meridiem” and refers to all times from midnight until 11:59
in the morning. PM means “post meridiem” and refers to all times from noon
until 23:59 at night.