EasyManua.ls Logo

Sonoro iElements - Radio Operation Guide; Selecting the frequency band; Scanning stations; Presetting stations

Sonoro iElements
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English
17
7. Radio operation
7.1 Selecting the frequency band
WhenyouriElementshasbeenswitchedon,itwillstartinthelastselectedplaybackmode.
By repeatedly pressing the
symbolyoucanswitchbetweentheplaybackmodes
(FMradio,AMradio,iPod,Aux).
InFMradiomodeyoucanreceiveFMradiostationsandintheAMradiomodeyoucan
receiveAMradiostations.ForfurtherinformationonAuxoriPod,pleaserefertosections9.2
or 9.6.
NOTE!
TheFMfrequencybandisbetween87.5MHzand108.0MHzonVHFband
II.TheAMfrequencybandisbetween522kHzand1620kHz(Europe)and
between520kHzand1710kHz(USA).
7.2 Scanning stations
Ifyouhaveselectedafrequencyrange(FMradioorAMradio),youcansearchforstations
withthe<<and>>buttons.
Pressingandholdingoneofthesebuttonsbrieyactivatesanautomaticscaninthe
corresponding direction. If a strong station signal is located, the automatic scan stops and
the radio station is played.
Youcanne-tunethestationfrequencybybrieypressingthe<<and>>buttons.
If you do not change the station frequency setting for approx. 10 seconds, the time appears
on the display instead of the station frequency.
NOTE!
Make sure that the antenna is properly connected and that the antenna
selectionswitchissetcorrectly.ItisnotpossibletoreceiveastationintheAM
range unless the supplied AM antenna is connected.
7.3 Presetting stations
YouriElementscansaveupto10stationsperfrequencybandinthepresetmemory.
Ifyouhavefoundastationthatyouwouldliketosave,pressthemenubuttontoaccessthe
menu.Nowpressthe<<or>>buttonuntilMEM SET appears on the display.
Nextselectoneofthememorypresetsfromp0top9withthe+and–buttons.The
subsequentmessageFREE or USED informs you whether the memory preset is still free or if
you have already assigned it. You can also re-assign previously assigned memory presets.
Conrmyourselectionwiththemenubutton.P 0...9 SAVED appears on the display.
Ifyouwouldliketocancelyourselection,simplydonotpressanybuttonforapprox.5
seconds.YouriElementsthenreturnsfromthemenutoregularplaybackmode.

Table of Contents

Related product manuals