Chapter 2: ZonePlayer Setup and Operation
2-3
Rear Panel Connectors
Ethernet switch connectors (4)
Use Category 5 Ethernet cable to connect to a router,
computer, or additional network device such as a
network-attached storage (NAS) device.
LED indicators:
• Green (link connection)
• Flashing Yellow (network activity)
Right speaker terminals
Use high-quality speaker wire to connect the right
speaker to the ZonePlayer.
Left speaker terminals
Use high-quality speaker wire to connect the left
speaker to the ZonePlayer.
Voltage select
(AC 115/230 V)
115 V (North American factory setting)
230 V (European factory setting)
AC power (mains) input
Use the supplied power cord to connect to power outlet.
Analog audio outputs (variable)
You may use a standard RCA audio cable to connect the
ZonePlayer’s analog audio outputs to the audio inputs
on a separate audio component, such as an amplifier or
your home theater receiver.
Ethernet
switch
connectors
Right speaker
terminals
Left speaker
terminals
Voltage select
115V/230V
AC power (Mains)
input
Analog audio inputsAnalog audio outputs
Subwoofer output
To Next Page
Loading...
