Chapter 5: Using Your Sonos Controller
5-21
Turning Off the Status Indicator Light
If you have a ZonePlayer located in a bedroom, you may want to turn off the white
indicator light that appears on the front of the ZonePlayer. This means that while the
ZonePlayer is in ‘normal’ operation, the light will be off. However, if the Status Indicator
Light begins to flash amber, see "ZonePlayer Status Indicator Explanations" on page A-
5 for additional information.
1. From the Music menu, select System Settings→ZonePlayer Settings and touch
OK.
2. Use the scroll wheel to highlight the zone you wish to affect, and touch OK.
3. Select White Status Indicator Light, and touch OK.
4. Select On to turn the light on during normal operation, or Off to turn the light off
during normal operation.
Adjusting Your Controller’s Settings
From the Music menu, select System Settings→Controller Settings and then use
the scroll wheel to highlight the preference setting you wish to change.
Click sound. Adjust this setting to turn the Controller’s scroll wheel “clicking” on or off.
Sleep timer undocked. Use this setting to select the amount of time after which your
Controller enters light sleep mode when not connected to a power supply. The screen
will turn off until motion is detected or a button is pressed.
Sleep timer docked. Use this setting to select the amount of time after which your
Controller enters light sleep mode when plugged into a power supply. Because the
Controller is connected to a power supply during this time, you can set this sleep timer
significantly higher than the undocked sleep timer setting.
Motion sensor. Use this setting to turn the motion sensor on or off. The motion sensor
automatically wakes your Controller when motion is detected.
Screen brightness. Use this setting to adjust the brightness of the screen display.
Button brightness. Use this setting to adjust the brightness of the button display.
To Next Page
Loading...
