The setting is reset without the resetting operation.
• Tile battery pack was removed when tile power switch was set to ON. When
removing the battery pack, make sure the camera is turned off and the
access lamp is not ilhnninated (pages 17, 37).
The camera does not work properly.
• Turn off the camera. Remove the battery pack and insert it again. If an AC
Adaptor (sold separately) is used, disconnect the power cord. If the camera
is hot, allow it to cool down belbre trying this corrective procedure. If the
camera does not work after doing these solutions, consult your Sony dealer
or local authorized Sony service t?tcility.
The five bars of the SteadyShot scale flashes.
• The SteadyShot function does not work. You can continue to shoot but the
SteadyShot function will not work. Turn the camera off and on. If the
SteadyShot scale continues to flash, consult your Sony dealer or local
authorized Sony service facility.
"--E-" is indicated on the screen.
• Remo_.e the memory card, and insert it again. If this procedure does not turn
off the indication, t_rmat the memory card.
163
To Next Page
Loading...
