Sony alpha 330 - Page 4

RegulatoryInformation
Declaration of Contormity
Trade Name: SONY
Model No.: DSLR-A331)
Responsible Party: Sony Electronics
Inc.
Address:1653/) Via Esprillo,
San Diego, CA 92127 U.S.A.
Telephone No.: 858-942-223/)
This device complies with Part 15 of tile
FCC Rules. Operation is subject to the
following two conditions: (1) This
device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
Declaration of Conlormity
Trade Name: SONY
Model No.: DSLR-A381)
Responsible Party: Sony Electronics
Inc.
Address:16530 Via Esprillo,
San Diego, CA 92127 U.S.A.
Telephone No.: 858-942-2230
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: ( 1) This
device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
CAUTION
You ale cautioned that any changes or
modifications not expressly approved in
this manual could void your authority to
operate this equipment.
Note:
This equipment has been tested and found
to comply with tile limits for a Class B
digital device, pursuant to Part 15 of tile
FQC Rules.
These limits ale designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses. and can
radiate radio frequency energy and. if not
installed and used in accoMance with tile
instructions, may cause harmful
interfclence to radio communications.
However. there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interl'clence to radio or television
reception, which can be determined by
turning the equipment off and on. the user
is encouraged to tW to correct the
interference by one or more of the
following measures:
Reorient or relocate tile receiving
antenna.
lncrease the separation between tile
equipment and receiver.
Connect the equipment into an outlet
on a circuit dill)lent from that to which
tile receiver is connected.
Consult the dealer or an experienced
mdio/TV technician for help.
The supplied interface cable must be used
with tile equipment in order to comply with
the limits for a digital device pursuant to
Subpart B of Part 15 of F(C Rules.