2-6
CCP-8000 IM
*1 : Installation of the MKS-8031TB requires installation
of the track ball after the module is installed in steps 1
to 5.
Install the track ball by following the procedure
below.
6. Rotate the ball cover counter-clockwise to release the
lock.
7. Remove the ball cover and the track ball.
8. Rotate the ball cover clockwise until it is locked.
4. Installation of the MKS-8025 to the MKS-8076
(Memory Card/USB Adapter)
Applicable module
. MKS-8025 Memory Card/USB Module
Installation
1. Remove the module covers from the both sides of the
MKS-8025.
2. Loosen the four screws (with drop-safe) fixing the
MKS-8025.
3. Remove the MKS-8025 by holding the two screws on
the sides of the MKS-8025.
4. Disconnect the harness from the MKS-8025 connector.
5. Connect the harness of the MKS-8076 to the connector
of the MKS-8025 (new).
6. Install the MKS-8025 (new) and fix it by tightening
the four screws (with drop-safe) on both sides.
7. Install the module cover.
m
. The number of the MKS-8025 that can be connected
to the MKS-8010/8010A is only one unit.
. When you want to joint it, install MKS-8025 at the
top end. (Refer to Fig. 1 (on page 2-8.))
Ball cover
Track ball
MKS-8031TB
Connector
MKS-8025
MKS-8076
Screws
(with drop-safe)
Screws
(with drop-safe)
Module covers
2-4. Installing the Operation Modules
To Next Page
Loading...
