Sony CDP-991 - Repeat Playback Options; Single Track and A-B Segment Repeat

Piaying Repeatedly - Repeat Play
Repeat play: Allows you to repeatedly play all selections or one particular
selection on your disc in any play mode.
A-B repeat play: Allows you to repeatedly play a particular portion (starting with
point A and ending with point B) on your disc. Useful for
learning foreign languages or lyric lines.
Repeating Selections
REPEAT
Press REPEAT before or during play.
REPEAT
eT
Lights up.
The player repeats the current playing mode.
Playing mode
Continuous play
Selections to be repeated
All the selections or a single
selection
Delete play Repeat playing selections
except deleted ones
Shuffle play Selections that the player
Delete shuffle play
Program play
reshuffles
All the selections programmed
in the same order
Between the specific custom
indexes
Custom index play
To repeat a single selection
Press REPEAT again during repeat play of the continuous
or delete playing mode. REPEAT 1” appears.
To cancel repeat play
Press REPEAT again. “REPEAT” disappears. To cancel
repeat play of the continuous play, press “REPEAT” until
“REPEAT” disappears.
Note
Repeat play cannot be conducted on multi-disc programs.
Repeating a Particular Portion
- A-B Repeat
1 Press A--B at the starting point (point A) of
the portion to be repeatedly played.
A~-B
“A SET” is displayed and ‘“A-” blinks.
2 Either continue playing the portion or press
PP to reach the ending point (point B) of
the portion and then press A<B again.
A=~8
“REPEAT A-B” appears.
The player memorizes the ending point (point B)
and repeat play the specified portion starts.
To set a new starting point
Press A<+B repeat during play in the A-B repeat mode.
The ending point (B) becomes the new starting point (A)
and play is continued.
To designate the new ending point (B), press A<-B repeat
again at your desired place.
The new A-B repeat portion is set.
You can advance the portion by repeating the above
operation.
To cancel A-B repeat
Press REPEAT.
Going back to the same point (A) from any point on
the disc
Press A<>B to designate the desired point (A). (Point B
need not be designated.)
You can go back to point A from any point on the disc by
simply pressing >.
Note
You cannot designate point A and B in two different selections. 4 9