Sony CDP-991 - Additional Information; Maintenance and Cleaning Procedures; Technical Specifications

Chapter 5 Additional Information
WEViahtctatelevexss SJ of Led p iter} ice) atc)
Clean the cabinet, panel and controls with a soft cloth
lightly moistened with a mild detergent solution. Do not use
any type of abrasive pad, scouring powder or solvent such
as alcohol or benzine.
Cleaning Discs
When a disc becomes dirty, clean it with a cleaning cloth.
Wipe the disc from the center out.
Do not use solvents such as benzine, thinner, commercially
available cleaners or anti-static spray intended for analog
discs.
42
Compact disc player
Frequency response
Signal to noise ratio
Dynamic range
Harmonic distortion
Channel separation
2 Hz- 20 kHz +0.3 dB
More than 115 dB
More than 100 dB
Less than 0.0025%
More than 110 dB
Outputs
LINE OUT (FIXED) Output level 2 V (at 50 kilohms,
non DSP mode)
(phone jacks) Load impedance over 10 kilohms
LINE OUT (VARIABLE) Output level max. 2 V
(phone jacks) (at 50 kilohms, non DSP mode)
Load impedance over 50 kilohms
DIGITAL OUTPUT Wave length 660 nm
(OPTICAL) Output level —18 dBm
(optical output
connector)
HEADPHONES Output level max. 28 mW
(stereo phone jack) Load impedance 32 ohms
General
Power requirements 120 V AC, 60 Hz
Power consumption 17W
Dimensions Approx. 430 x 110x355 mm
(w/h/d)
(17 x 43/3 x 14 inches)
Including projecting parts and
controls
Weight Approx. 4.6 kg (9 Ibs 15 oz), net
Remote commander (RM-D997)
Remote control system Infrared control
Power requirements 3 V DC with two batteries size
AA (IEC designation R6)
Dimensions Approx. 6218175 mm
(w/h/d)
(21/2 23/327 inches)
Weight 135 g (4.6 oz)
Including batteries
Supplied accessories
Connecting cord (1)
(2 phono plugs <> 2 phono plugs)
Remote commander (1)
Sony SUM-3(NS) batteries (2)
Optional accessory
Audio optical connecting cord POC-15
Design and specifications are subject to change without
notice.