Sony CDP-991 - Hooking Up the System; Connecting to Amplifiers and Audio Systems

Hooking Up the System
You can connect the player with analog or digital signal depending on your
amplifier or D/A converter.
Before you begin, remember the following;
* Turn off the power of each unit before making connections.
* Connect the AC power cord last.
¢ Be sure to insert the plugs firmly into the jacks. Loose connection may cause hum and noise.
* Leave a little slack in the connecting cord to allow for inadvertent shock or vibration.
* Cord plugs and jacks are color coded: Red plugs and jacks are for the right channel (R) and white ones for the left
channel (L).
Connecting an Amplifier Directly
VARIABLE LINE OUT CDP-997 Speaker system
outlet
When connecting to an amplifier or
D/A converter with OPTICAL IN, use
DIGITAL OUT (OPTICAL) instead of
LINE OUT.
~ Soe Take off
the cap.
Amplifier
Plug in firmly.
to a wall outlet
Note on DIGITAL OUT (OPTICAL) Note on LINE OUT
When connecting with DIGITAL OUT (OPTICAL), use the FIXED: The output level is fixed.
POC-15 audio optical connecting cord (not supplied). VARIABLE: The output level can be adjusted with the LINE
Please note that when the digital out is connected, fade OUT/PHONE LEVEL or LINE OUT LEVEL on the
out, fade in, time fade, level file and DSP file functions remote commander.
cannot be used. * Connect your system to the VARIABLE output when
using level file.
° If the LINE OUT/PHONE LEVEL is adjusted while
recording, the recording level be changed even when
it is preset on the tape deck.