Sony CDP-991 - Chapter 2: Getting Started; Unpacking and Initial Setup

Chapter 2 Getting Started
WT al ey-Cer dare]
* Place the player in a location with adequate air circulation
to prevent internat heat build up in the player.
¢ Do not place the player on a soft surface, such as a rug
that would block the ventilation holes on the bottom.
* Do not install the player:
—near heat sources such as radiators or air ducts.
-in a place subject to direct sunlight, excessive dust,
mechanical vibration or shock.
Checking the Supplied Accessories
Make sure that all supplied accessories are included with
your player. This manual and the following items are
included with your CDP-997.
¢ Audio connecting cords (1)
« Wireless remote commander RM-D997 (1)
* Sony SUM-3(NS) batteries (2)
Note on Protective Sheet
The tape on the table should be removed after loading the
compartment.
Protective
sheet
Protective
tape
(or atoley-t ale M-MClelele me meser-Lace)a] Inserting the Batteries into the Remote
Commander
1 Open the cover.
2 Insert two size AA(R6)
batteries with
correct polarity.
Battery life
* About half a year of normal operation can be expected
when using the Sony SUM-3(NS) batteries.
* When the batteries are run down, the remote commander
will not operate the player. In this case, replace both
batteries with new ones.
Notes on the remote control operation
¢ Avoid exposing the remote sensor to direct sunlight or
lighting apparatus. Such exposure can cause a
malfunction.
* To avoid damage caused by battery leakage and
corrosion, remove the batteries when the commander will
not be used for a long time.
Conventions
[4] This symbol shown in the manual headings indicates
a function operated only from the remote
commander.
Ly i)
A This symbol shown in the manual headings indicated
a function operated only on the main player.