Sony CDP-991 - Custom Index Playback and Clearing; Navigating and Removing Custom Indexes

Playing from the Desired Custom Index Clearing Custom Indexes
There are three ways to play from a desired custom index.
a) To play from an index to the end of the disc 1 Press C.INDEX.
1 Press C.INDEX. C.INDEX appears.
2 Select the desired custom index by pressing the
corresponding numeric button 1 through 10.
2 Press CHECK.
Each time you press CHECK, index number blinks.
By Ts piny. trom one index te thesnext Select the index number you want to delete.
1 Press C.INDEX twice so that “‘C.INDEX 1” and
“SINGLE” are displayed.
2 Select the desired custom index by pressing the
corresponding numeric button 1 through 10.
3 Press ERASE while index number blinks.
To play repeatedly between adjacent indexes
Press REPEAT between steps 1 and 2 above. To cancel repeat play,
press REPEAT again.
c) To access an index during play i
1 Press C.INDEX The specified index will be erased and the
2 Press 4—/—% on the remote commander. succeeding index numbers will move up one.
—: Accesses the next index.
4—; Returns to the preceding index.
(to go further back, use the numeric button.)
To release play using custom indexes
Press one of the PLAY MODE buttons (PROGRAM,
SHUFFLE or CONTINUE). The music calendar appears.
Recommended application of custom indexes
When the selections on your disc are symphonies or
concertos, their selection number is not useful for locating
their chapters. In this case, you are recommended to
assign a custom index to each chapter so that you can
locate it easily. When you want to play only one chapter,
you are recommended to choose Custom Index 1 (Single).
37