Sony CDU-541 - Page Code Seven: Verify Error Recovery Parameters; Page Code Eight: CD-ROM Parameters

--..--
'-....-
CDU-541 CD-ROM DRIVE SCSI INTERFACE MANUAL
5.3.1.3. Page Code Seven
Table 5-41: Page Code Seven: Verify Error Recovery Parameters
==============================================================================
Bitl
Byte 1
7
6
5
4
3
2
1
a
==============================================================================
o I Reserved I Page Code (07h) I
-----1-----------------------------------------------------------------------1
1 I Parameter Length (06h) :
-----l-----------------------------------------------------------------------1
2 I Error Recovery I
-----l-----------------------------------------------------------------------1
3 I Verify Retry Count
-----1-+---------------------------------------------------------------------
4 I Reserved
-----1-----------------------------------------------------------------------
5 1 Reserved
-----1-----------------------------------------------------------------------
6 I Reserved
-----1-----------------------------------------------------------------------
7 I Reserved
==============================================================================
The implementation of error recovery procedures for verification operations
is the same as for read operations on CD-ROM devices.
5.3.1.4. Page Code Eight
Table 5-42: Page Code Eight: CD-ROM Parameters
==============================================================================
Bit I
Byte I
7
6
5
4
3
2 1
o
=============================================================================-
o I Reserved I Page Code (08h)
-----i-----------------------------------------------------------------------
1 I Parameter Length (02h)
-----1-----------------------------------------------------------------------
2 I Reserved I LBAMSF
-----1-----------------------------------------------------------------------
3
I
I
Reserved
Inactivity Timer Multiplier'
==============================================================================
The LBAMSF bit if zero indicates that the target will use the logical block
addressing mode. The LBAMSF bit, if one, indicates that the target will use
the minutes-seconds-frame addreSSing mode. The LBAMSF bit applies only to
Group 6 commands implemented for the CD-ROM device type. The default value
of the LBAMSF bit is zero.
5-73