Sony CDX-51 - Mechanical Adjustments

COVER (MD) ASS’Y AND ESCUTCHEON
O screw
© screw F
4PTT2 x 4 (S) F
Se ee
x
@ cover (MD) ass'y
® escutcheon (2)
EV CHASSIS ASS’Y AND CHASSIS (MZ2) ASS'Y
| QO +PTT2x4
@ EV chassis block ass'y
© polyethylene
washer
ass'y
@ lever (X) ass'y (2)
lever (X) ass'y (2) — ly
@ lever (X) ass'y (2) S VES
.
g
©
@
polyethylene
washer
1) polyethylene ee = @ lever (X) ass'y (2)
washer
© screw
G-—— © Sprt2 x 4 (8)
ROLLER (LOWER) AND DPT BOARD AND ARM (NR) ASS’Y
© compression
spring
© arm (NR) ass'y
®
compression
@
slide
lever
spring
rT
@
roller
(lower)
j
_@
roles
Beat
®
bearing
(roller)
© connector from CNP402 on
sensor
board
A=-—_——
®
polyethylene
washer
© screw
+PTT2 x 4 (S)
b
© teen © toler
©
stop
ring
(SL)
2.0, type-E —may
© DPT board Be
f
@ screw wy
SPrT2 x 4 (8) ah
© bracket (DPT2)
SECTION 3
MECHANICAL ADJUSTMENTS
3-1. ELEVATOR HEIGHT ADJUSTMENT 2. Fit the rack assembly putting it in the arrow @ direction. At this time
insert a spacer (approx. 1 mm thickness) or fit the rack assembly
This adjustment should be done when replacing the rack assembly on the while pushing the EV chassis assembly in the arrow ® direction.
parts related to it.
Procedure : rack ass'y (2) +PTT2 x4
1. Fit the EV gear assembly after adjusting its slit position as shown in
the figure. (When the slit position is out of order after fitting, it can be
adjusted finely by turning the worm gear of the ELV motor.)
EV chassis ass'y
+PTT2 x4
slit
EV gear ass'y
So)
eas
(slit position)
Note : When this adjustment is out of order, it doesn’t operate normally
and the roaring of the motor can be heard. In this case adjust
again.
—10—