Mass: Approx.
1.2
kg
(2
Ib
II
oz)
Supplied accessories:
Card remote commander: RM-X151
Parts for installation and connections (I set)
Optional accessories/equipment:
BUS cable (supplied with an RCA pin cord):
RC-61 (I m), RC-62 (2
m)
Source selector: XA-C40
AUX-IN selector: XA-300
USB connection cable for iPod: RC-IOOIP
HD
Radio™
tuner:
XT-IOOHD
Your
dealer
may not handle
some
of
the above listed
accessories. Please ask the dealer for detailed
information.
Design
and
specifications are subject to change
without notice.
• Halogenated flame retardants are not used in the
certain printed wiring boards.
• Halogenated flame retardants are not used
in
cabinets.
• Packaging cushions are made from paper.
Troubleshooting
The
following checklist will help you remedy
problems you may encounter with
your
unit.
Before going through the checklist below, check the
connection and operating procedures.
If
the problem is not solved, visit the following
support
site.
Support site
http://esupport.sony.com
http://www.xplodsony.com/
No power is being supplied to the unit.
• Check the connection or fuse.
•
If
the unit
is
turned off and the display disappears, it
cannot be operated with the remote commander.
-+
Tum on the unit.
The power antenna (aerial) does not extend.
The power antenna (aerial) does not have a relay box.
No sound.
• The
ATT
function
is
activated.
• The position of the fader control "FAD"
is
not set for
a 2-speaker system.
No beep sound. _
• The beep sound
is
canceled (page
18).
• An optional power amplifier
is
connected and you are
not using the built-in amplifier.
The contents of the memory have been erased.
• The RESET button has been pressed.
-+
Store again into the memory.
• The power supply lead or battery has been
disconnected or it
is
not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition
is switched.
The leads are not matched correctly with the car's
accessory power connector.
During playback or reception, demonstration
mode starts.
If
no
operation
is
performed for 5 minutes with
"DEMO-ON" set, demonstration mode starts.
-+
Set "DEMO-OFF" (page
18).
The display disappears from/does not appear
in
the display window.
• The dimmer
is
set "DIM-ON" (page
18).
• The display disappears if you press and hold
(
SOURCE/OFF
).
-+
Press
(SOURCE/OFF)
on the unit until the
display appears.
• The connectors are dirty (page 21).
continue to next page
-.
23
To Next Page
Loading...
